The Explorer still hangs and dries. It's actually ready to sand out and polish now, but I've been focused on other things. Soon I will get back to it and wrap it up.
I got the bridge holes drilled for the `64ish Corvette. I also pulled the old frets then smoothed and leveled the board. It was really evident how small the old frets really where once they're out. I'll try to get a photo up.
A while back I acquired a fret bending tool for a great price. It's the roller kind that does great, consistent bends and is easy to use. I ran some Stew Mac fret stock I got off ebay through it and used some Titebond 1 to glue them in. I Dremeled the ends off last night and leveled them. Started the crowning process and ran out of steam before I could finish. This morning I finished crowning, rounding the ends and then did the polishing with my Micro Mesh. They look great. The wire is smaller than what I used on my `61 Corvette. I need to look up the exact dimensions, but it's kind of the width of current Gibson wire, but the height of current Fender wire. I nice compromise to my taste. I think I'm going to really like them. The tangs where not as deep as the old wire, but I still think they got plenty of bite into the rosewood.
Soooo, I hope to get back to sanding out the Corvette, addressing the headstock (going to try and save the original Gretsch decal) then on to grain fill, sand and seal, etc.
I've put my drill press away, back in the garage, but before I did I worked on that Bulldog LP kit some. I clamped the neck into the body. It's a tight, positive enough fit I knew I could do this to locate the bridge without having to glue yet. I got the bridge and stop tail locations calculated and drilled their holes based on dimensions for Gotoh parts, which is what i will eventually get for it.
Next I drilled out the tuner holes in the headstock to fit some mahogany dowel rod I have. I plugged the original holes with the dowels because they did not line up with the Gibson headstock overlay I'm using. After the glue had dried I trimmed and sanded everything flush and glued the headstock overlay on. It's the older style Gibson logo with the crown in the middle. Then I drilled new 10mm holes in the correct places and set everything aside for another day. I may or may not have the LP ready for finish before the weather turns too cold to paint outside. I'm not going to fret about it, if it happens, it happens. If not, it'll make a nice little winter project.
BTW....this is the leading contender for the Corvette refinish. A "natural burst". Basically just clear coated mahogany with a bit of transparent brown sprayed around the edges. I like it a lot.
 |
| From 66 Corvette work |
No comments:
Post a Comment